Spectral Doppler Measurements With 2-D Sparse Arrays

The 2-D sparse arrays, in which a few hundreds of elements are distributed on the probe surface according to an optimization procedure, represent an alternative to full 2-D arrays, including thousands of elements usually organized in a grid. Sparse arrays have already been used in B-mode imaging tes...

Celý popis

Uložené v:
Podrobná bibliografia
Vydané v:IEEE transactions on ultrasonics, ferroelectrics, and frequency control Ročník 67; číslo 2; s. 278 - 285
Hlavní autori: Mattesini, Paolo, Ramalli, Alessandro, Petrusca, Lorena, Basset, Olivier, Liebgott, Herve, Tortoli, Piero
Médium: Journal Article
Jazyk:English
Vydavateľské údaje: United States IEEE 01.02.2020
The Institute of Electrical and Electronics Engineers, Inc. (IEEE)
Institute of Electrical and Electronics Engineers
Predmet:
2-D arrays
3-D imaging
Acoustic noise
Acoustics
Apertures
Arrays
Bandwidth
Doppler effect
Doppler measurement
Engineering Sciences
Optimization
Phantoms
Probes
Signal to noise ratio
sparse arrays
Spectra
spectral Doppler measurements
Subgroups
ISSN:0885-3010, 1525-8955, 1525-8955
On-line prístup:Získať plný text
Tagy: Pridať tag
Žiadne tagy, Buďte prvý, kto otaguje tento záznam!
Popis
Shrnutí:The 2-D sparse arrays, in which a few hundreds of elements are distributed on the probe surface according to an optimization procedure, represent an alternative to full 2-D arrays, including thousands of elements usually organized in a grid. Sparse arrays have already been used in B-mode imaging tests, but their application to Doppler investigations has not been reported yet. Since the sparsity of the elements influences the acoustic field, a corresponding influence on the mean frequency (Fm), bandwidth (BW), and signal-to-noise ratio (SNR) of the Doppler spectra is expected. This article aims to assess, by simulations and experiments, to what extent the use of a sparse rather than a full gridded 2-D array has an impact on spectral Doppler measurements. Parabolic flows were investigated by a 3 MHz, 1024-element gridded array and by a sparse array; the latter was obtained by properly selecting a subgroup of 256 elements from the full array. Simulations show that the mean Doppler frequency does not change between the sparse and the full array while there are significant differences on the BW (average reduction of 17.2% for the sparse array, due to different apertures of the two probes) and on the signal power (Ps) (22 dB, due to the different number of active elements). These results are confirmed by flow phantom experiments, which also highlight that the most critical difference between sparse and full gridded array in Doppler measurements is in terms of SNR (-16.8 dB).
Bibliografia:ObjectType-Article-1
SourceType-Scholarly Journals-1
ObjectType-Feature-2
content type line 14
content type line 23
ISSN:0885-3010
1525-8955
1525-8955
DOI:10.1109/TUFFC.2019.2944090